I applied through an employee referral. The process took 1 week. I interviewed at Texas Instruments (Bengaluru)
Interview
Written test was there. Mostly from rlc circuits opamp etc. Written test consist of 20 basic electronics questions and 20 aptitudes mcq questions. They were mainly looking for mixed signal profiles. There was 3-4 questions from comparators, DAC and switched capacitors. After the written test was over they told to wait for 10 minutes. After that they announced the result. All 3 candidates were qualified. Then interview was a bit tough. The interview er were very helpful but they will thoroughly judge your credentials.
Interview questions [1]
Question 1
Start up circuit of a BGR ? ( from masters project)
fundamental circuit intuition, problem-solving skills, and deep understanding of device physics rather than just rote memorization of equations. You will be expected to think out loud, draw waveforms, and analyze small-signal
Online Assessment followed by 2 rounds of technical interviews. Online Assessment consisted of 3 parts - Analog, Digital and Aptitude. Analog part mostly consisted of questions from RC circuits, Opamps, MOS Circuits, Oscillators.
I interviewed at Texas Instruments (Bangalore Rural)
Interview
I am only having only one round of interview
Where they asked mostly about rc circuits. Op amp basics and mosfet questions.
The interview almost happened for 1 hour and it is a good experience